Re: hfs6 problems
 

rich, it worked! thanks, i grounded that wire coming from the solenoid (it was black), directly to the chassis.

thanks for the help!!! i was not looking forward to buying a new kit.

Re: hfs6 problems
 

Next, pick out the brown wire from the in-coming 8-core cable, cut it from the circuit board. Now connect it to the black wire from the coil (already disconnected from the circuit board)

Let me know.

Re: hfs6 problems
 

ok, so the brown wire will basically be crimped with the new wire i made? (brown and black from coil connected to one new ground wire).

Re: hfs6 problems
 

The black ground wire of the FCM is unrelated.

post a picture before I get confused. Mark the wires in question with numbers.

Re: hfs6 problems
 

here is what I got.

Re: hfs6 problems
 

Looking at the picture, are you connecting the black wire of the coil permanently to ground?

Re: hfs6 problems
 

correct. the small black wire coming off the coil is butt connected to a new wire and then grounded to the chassis. is this alright?

I cut the brown wire and left it until further instruction.

Re: hfs6 problems
 

No, you will burn the coil.

Disconect the black wire from ground and connect the end to the short brown wire. from the incoming harness.

Re: hfs6 problems
 

okie dokie, and that's all i need to do? brown wire from the main harness connected to black wire coming from the coil? and leave the other two ends blank

Re: hfs6 problems
 

OK, here is an illustration:

http://www.aquamist.co.uk/forum/H6-splice.jpg