waterinjection.info - Flow no more than 2 bars

Page 3 of 3

Show 40 post(s) from this thread on one page

waterinjection.info (http://www.aquamist.co.uk/forum2/vbulletin/index.php)

- Aquamist HFS-3 forum (http://www.aquamist.co.uk/forum2/vbulletin/forumdisplay.php?f=34)

- - Flow no more than 2 bars (http://www.aquamist.co.uk/forum2/vbulletin/showthread.php?t=2289)

Richard L

11-05-2013 12:59 AM

Re: Flow no more than 2 bars

Good.

I will make a diagram for you the exact location. Let me you the serial number of your controller.

I suspect a dry solder joint may have caused this.

sticker

12-05-2013 09:52 PM

Re: Flow no more than 2 bars

Quote:

Originally Posted by Richard L (Post 18815)

Good.

I will make a diagram for you the exact location. Let me you the serial number of your controller.

I suspect a dry solder joint may have caused this.

Small sticker says SN: 100638
smaller sticker just above it: 12-135-150

sticker

15-05-2013 10:11 AM

Re: Flow no more than 2 bars

Quote:

Originally Posted by Richard L (Post 18815)

Good.

I will make a diagram for you the exact location. Let me you the serial number of your controller.

I suspect a dry solder joint may have caused this.

any updates?

Richard L

16-05-2013 07:44 AM

Re: Flow no more than 2 bars

The controller needs to be reflashed for a lower flow table. The system is flashed for a twin jet operation from factory. Can you send the circuit board back to us:

write: "return to manufactuer for repair" on the package or import tax will be added
ERL Ltd
Iroko House
Bolney Avenue Peacehaven
East Sussex BN10 8HF
England

Attn: Richard

sticker

16-05-2013 12:55 PM

Re: Flow no more than 2 bars

Quote:

Originally Posted by Richard L (Post 18837)

how this could be connected with no change of V on pin22 relative to ground withc SC change. As I understand it could not be connected with high flow table. mb first I should check for dry solder?

All times are GMT +1. The time now is 06:23 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page