Hi Ed,
Thanks for the advice on jet size. You're right, it would make sense to go with .5mm jets. I'm leaning toward using a GPO for hsv control, since that would allow me to stop firing the valve completely under light load/low rpm conditions and customize a map over the rest of the matrix. The .5mm jets should flow plenty of water, especially at high rpms when there's less time available, and if they're off at low rpms then I don't have to worry about exceedingly short on-times to keep water flow at a low rate.
It'll probably be mid May before I get everything installed and ready to tune (got other things I also need to do. Bummer...). I'll post my experiences as interesting things happen. In the meantime, other people's comments and experiences would be welcome.
|