[blk01s4]

Ok new update, you know that black cable that goes between the board and the gauge? Initially when I hooked this system up it was like loose the gauge would turn on and off by itself. The vendor that sold me the system sent me a replacement black cable and now the guage stays on all the time. Except that new cable must have a problem also because like I said the SC setting didnt do anything when making adjustments. I plug in the original black cable and now suddenly the SC dial works. The original black cable still has the problem with the gauge turning on and off. So out of two black cables both are bad ! Argh. I could recrimp it again, although it does appear to be a larger connection then RJ45.

I guess the question is does Aquamist have a lot of problems with these cables causing the gauge to flicker on and off?

Now with SC set to 6 bars as instructed and WL set to full counter-clockwise and WH set to full clockwise and the system activated with TST advancing WL clockwise never distinguishes the 'B' light. I can turn it in back and forth it does nothing B light stays on.