That is correct with a system 2d you want the flow potential at the jet to a target ratio of your injection system. The 2d will then reference your IDC and when they are both for instance running at 80% then you will get around your target ratio of water/fuel - in this case the 264 you calculated.
What this means to you is that you do want the flow potential of 330cc, but as long as you aren't going over 80% IDC you won't ever use more than 264cc (aquamist pump max is 300cc without an accumulator or priming pump).
The 330 point is actually the 1.0mm jet (labels are to the right of the point, not above).
I would consider an accumulator just to make sure you have some overhead on the pump potential.
|