Re: Water injection and water level lights after hitting threshold.
Alright, so I will check at lunch time but the red
Connector to gray plug is tapped to dme power or similar. I checked other pins and all of the power wires I tested had the same result. Now I tested the system and everything works , I get progressive spraying and flow is registering. I remedy the pump issue after power down by turning off the gauge before engine shutdown and I have no issue. It is weird however how I get the three injecting lights on the PWM module after shutdown , with or without the gauge on.
Now when I do inject, the water injection light illuminates , then water level , until It is done injecting. If I remember correctly this indicates the fail safe is active, however I don't want any fail safe setup. Which jumpers should I remove or place to achieve this?
Sorry for the long post!
|