[M35_wgn]

Hi everyone

Almost everything I have read about nozzle location suggests just after the intercooler as the best location. That is also the easiest for me (I have ~1.5m of pipework before the plenum), however the intake air has to take a couple of turns before getting into the plenum itself - the last is 90 degree (sorry, tried to attach pic but not working).

Would this cause the water/meth to condense on the outside of the bends?

I have a plug at the back of the plenum that would make a decent injection point, but want to achieve the best results. can anyone (Richard?) offer some input?

Cheers.