Re: Gain setting issue -HFS-3
Thanks for your prompt response / replacement suggestion Richard!
Due to sh!t weather I decided to skip testing whether the contorller sees the fuel IDC properly today, instead I measured the gain trimmer pins resistance with a multimeter (I'm not good in electornics so I'll explain in layman terms ))) The trimmer has 3 pins, when turning the knob clockwise resistance between one pair (lets call it central-left) reduces from 10 kOhm to almost 0, resistance between the other air (central-right) increases from 0 to 10 kOhm respectively.
On a first glance looks like a normally working potentiometer to me - so maybe my flow issues are not due to cotroller in the end... Are the resistance values I observed OK?
I will go on testing how the controller sees the fuel IDC tomorrow if the weather will be better.
Last edited by leman_opc; 21-07-2013 at 05:42 PM.
|