And now this is the data in volt reading.
I simply enter the conversion as below:
0v = 0v
5v = 5v
Again, the first 0.5v is standby so no wmi at that point, and every 0.5v increment afterwards represents 1 bar.
I have dialed in 6 bar maximum on my gauge display, so I want to see 3.5v maximum:
Bingo, the voltage went 3v+.
And I see 1.96 voltage at 19.42% IDC, so that should equal up to 3 bars.
What this then tells me I am injecting very early. Well, earlier than I thought. If all I think is correct, I am injecting below at somewhere below 20% F-IDC, with my TRSH dialed at 1 notch after 9 o'clock.
I do feel I am a bit too ahead of myself and obviously this is just my dummy analysis to quickly see where my WMI is currently is triggered.