Re: causes for irratic or low flow readings
Has been in about 4 months now, was mapped/dyno'd for meth without and issues (produced very good power increase straight away with a very mild map)
As I pour the methanol into the di-ionisde water it forms thousands of tiny bubbles and the mix heats up slightly, is this normal?
Or just the bubbles in the tank abnormal
I did have a tiny leak on the intake side of the pump so must of sucked air in at some point but have purged since
Have swapped my flow sensor for a spare I had that seems to require allot less effort to produce a noise and works in both directions, is it possible for debris to get stuck in the hall assembly?
|