Hi,
Wich pin should I use to log when WI is triggered??
Regards.
Quote:
Originally Posted by Richard L
Here are some useful pins for data logging:
#5 ........... System start-up: 12V = system on.
#6 ........... Flow sensor signal: 0.5 to 4.5V
#7 ........... Water level sensor: 0v= empty, 5v= not empty
#8 ........... Fuel injector (-). not direct injection.
#16 ......... IDC% signal: 0 to 5V
#17 ......... MPS signal: 0 to 5V (signal conditioned)
#18 ......... IDC% to the water injection valve
#23 ......... System power: 12V (switched/fused)
|