Quote:
Originally Posted by jmb614
Everything has gone well so far on testing the system and seems to work without issue but unfortunately were stuck at the sensor calibration. Currently we are using a single .7mm nozzle with a .5mm restrictor at the FAV valve. With a jet spraying out of the engine while calibrating the flow sensor we can only get 1 bar to light up with the sc potentiometer turned max right. What is our best course of action to get the bar graph to operate properly?
|
You need to change the flow table to a lower one. Do it by solder linking the 1&2 on the bottom side of the circuit board. Page 21 of the user manual.
Where did you buy the system from? Most aquamist dealers would give you aftersales support so you don't need to post on this forum.
Above all, do "read" the user manual first. This forum is not effective for this kind of basic support.