Found the problem... at last!
Totally **unrelated** to the Aquamist Kit ; unfortunately, the first time the problem occured was *immediately* after the ERL Aquamist pump. When it does happen right after an installation(the problem), well you tend to point at it and think it's the source of the problem.
Problem was the O2 Sensor wires that were sending intermittent signals ; wires were not installed correctly back last spring and were too close to the exhaust line, making them melt slowly but surely... Proper relocation et insulation solved the problem.
With correct O2 signal, everything is fine... Pumpin' good!
|