Re: No bars on gauge.
I was away for the last two weeks. But I could not find an email form you. What is you email address so I can check back.
Addressing the issues:
1. Spray at start up: wire the red of the grey harness to the injector(+) and green to the injector(-). This would solve your pre-crank problem.
2. Blow intro the detached flow sensor tube and let me know if you hear whirling sound. Make sure the sensor C-clip is in position.
3. When you do the test spray are there any fluid coming out of the jet?
__________________
Richard L
aquamist technical support
|