It would be nice if I had seen the instructions before :lol:
Without them, my natural feeling was to do it the other way round. I am a Contrarian I guess :wink:
My take was that the insertion pillar is used to push the fitting, apparently it's meant to grab and pull it, lol...
Following the new-found instructions, the overall result looks neater on the outside, but not on the inside (where the large side sticks in the airflow)
Following my way, it looks neater on the inside but not on the outside. There is also some millimetres extra 'shrouding' of the nozzle, but I'm not sure if it makes any difference.
|