Hi mate. Now you are running pretty much the same spec as me, do you also have the dip in power like me?
Re. the jet gitting, I had a section of alloy welded onto the pipe (thanks dad), then drilled and tapped that - it does seal, no worries there. The loss in power can be seen by turning the system on and off, so it is nothing to do with bad installation.
I have the bits to plumb in a second jet, which I will do once these existing issues are rectified. I will most likely spray onto the IC too.
As above, I'll be moving the primary jet to a point after the inlet temp sensor and Richard will be working on "fudging" the AFM signal.
|