Thank you Richard, I appricate your time very much.
Order placed, payment arranged. Please let me know when order will get dispatch.
At this stage I cannot do much but wayt for parts to test so I can confirm our electronics configuration circuitry. By the way this is the specs for set up. Anyone's comment welcome :smile:
----------------
WI system specs
General:
System to have rectifier bridge and filter for electronics to prevent reversal of polarity feed and take out possible spikes (voltage regulator 12V for electronics?) and on board fuse. Also to have on board supercap for temporary chip?s memory back up.
User interface:
? UP & DOWN, RIGHT & LEFT, ENTER buttons for menu
? Backlight ON/OFF button
? LCD screen
System Memory:
? MS memory card (of similar)
System inputs:
? Injector duty cycle (two inputs)
? MAP sensor absolute
? MAP sensor differential
? EGT temperature sensor
? Ambient Temperature sensor
? Turbine discharge temperature
? Engine intake temperature
? Engine block temperature
? Knock sensor signal
? Water low sensor(selectable 12/ground/sensor pin)
? Ignition ON (activation)
? Power (12V/15A input)
? Pump power supply interruption ( build-in over pressure sensor)
System outputs:
? Pump voltage control
? HSV duty cycle control (two independent outputs for future use .CPU support? )
? Solenoid ON/OFF control (2 / one for IC spray, one for water flow cut off)
? System programmable output (two / +12/ground)
--------------
Specs to be confirmed as hydrolic hardware get tested.
|