Options for 700HP 2.0L using Standalone ECM

[dsddcd]

Okay, I can't seem to find much information on the Aquamist components so I will throw this out there. Every time I try and download the manuals I get an error and several of the kits are not listed on the website that I can find.

I have a car that I am looking to make 650-700HP using a 2.0L block with app 22-25PSI of pressure. I will not be using meth fulltime it will only be used with my nitrous fuel and ignition maps along with high boost map. I have been looking for a meth kit for a while and I found the Aquamist HSV which is exatly what I wantd. Unfortunatly I am still new at this and need a few things to get the system going.

Essentially I have looked at (3) options for my kit but I am interested to hear any opinions:

(1) 2C kit ? Will the pump support the kind of flow-rate I will need? Exactly what kind of signal does the regulator send out? I am not sure if my AEM EMS can handle anything but switched input and use the signal as a safety.

(2) HSF-5 ? Will the pump support what I need, and what is the difference between the mag drive and Shurflow?

(3) Build my own including but not limited to the following:
1 Gallon Reservoir
Reservoir Float Switch
Pressure Switch
Flow Switch
Pump (Shurflow or Mag Drive)
HSV
Nozzles
Check Valve
Misc relays and tubing


Based on my calculations I will need approximately 300-400 cc/min based on a 4000 cc/min fuel supply. Is it better to use multiple nozzles to obtain a good atomization pattern?

I have looked at the DDS-3 but I have no place for a gauge so is there a cheaper alternative w/o a gauge.