|
#1
|
|||
|
|||
system 2d mini cooper s 2005
Hi, I'm in Italy, scuse me for my English.
I have buy a aquamist system 2d, and I want install this on my mini coper s 2005. I have see the beautifull installation here in this forum, but I have any question: In the aquamist box I have 3 jet, 0.7-0.8-0.9 What jet I can install? and at what pressure? (I want use 50% water 50% methanol) And the pressure sensor where can I install? next jet is good? last question, what is the difference if I connect the two wire (red and green) at the fuel injector o if I connect the red wire at 12v switched? tanks |
#2
|
|||
|
|||
You have not reply for me?
|
#3
|
|||
|
|||
Re: system 2d mini cooper s 2005
Quote:
I think a 0.7mm jet will be good. I thinh the system shoudl come on at about 5 psi. (factory set to 10psi). I would insrtall the pressure (with rem,ote hose) to any where after the intercooler. It is better to connect the red wire to fuerl injector (+). Or ignition switch position 2 (pre-cranking). Never at the accessories 12V supply. I guess you have seen this installation? http://www.aquamist.co.uk/phpBB2/viewtopic.php?t=1166
__________________
Richard L aquamist technical support |
#4
|
|||
|
|||
thanks for the reply, Yes, I have seen this installation.
Tomorrow I start install. Thanks again |
#5
|
|||
|
|||
Hi, I have install all, all ok, now I test the system.
But a question: for a good work it is better to install a small jet with high pressure or large jet with low pressure? thanks |
#6
|
|||
|
|||
For the mini. Go for a 0.7mm jet for 50% methanol.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
last night I tested the system in the street, everything perfect, a missile!
thanks thanks thanks!!! |
#8
|
|||
|
|||
This is good news. Any pictures of the install?
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
Hi Richard, I'm working a lot, but when can put my photos.
Now my system have a problem, when I turn on the engine, the red light comes on for 5 seconds and when I go, and the system should inject the water, the red led comes on again. I have tested, if I unplug the hose from the regulator valve to the speed valve, the pump runs faster and the blue LED lights. as I go, the green LED on the FIA 2d beats normally and when I push, the red led on fia 2d beats normaly. The fuse are good. I have a problem at the speed valve? or wath? thanks. |
#10
|
|||
|
|||
If the red led comes on, it is most probably a small amount of air is in the system.
Once you have air in the system the system will re-start , trying to re-prime the system. Try loosen one of the blanking plug on the 806-201, allowing water/air to vent off the system. Once primed, the water will leak out of the plug steadily.
__________________
Richard L aquamist technical support |
|
|