Need Help 2s Install, completely stumped

[jesuscookies]

Okay I have been trying to get this 2s to work on my car for the past month, and quite frankly I do not know what to do next. :cry:

I am utilizing the stock wiper bottle, and stock wiper bottle pump. It sits very low in my car. About 6 inches from the ground. My aquamist pump, on the other hand, is about 24-36 inches higher than the lowest point of my water bottle. I did this due to fitment issues. A pulse extender was built for me, and it was installed according to the diagram that Richard has posted on this forum, along with a relay.

When I start the car, the pump primes, but the winshield wipers go off as well. I can pull one wire off of the relay and the winshield wiper problem seems to go away. Pump still seems to prime. However, from this point pump will not prime again. Unless, I hit the windshield wiper cleaner switch in my car. When I do this the windshield wipers go off, the pump primes and I get a fine mist out of the nozzle.

I have tested the system otherwise, and can get all lights to go on. Including the, rpm, input threshold, and the inject light, but only droplets of water come out. Fault light has never turned off.

Here is exactly how we tested the system. With the car on. I used a pump with a guage to simulate boost in the system. This triggers the input threshold light to come on. Next I have the water enrichment potentimeters full open at 2K and 3K RPM. I give it gas, to 2K then 3K while simeltaneously pumping the boost hose. All lights light up but only a drop or 2 comes out of the pump.

Does anybody have any suggestions on what I should do from here?