|
|
#3
31-08-2009, 12:14 PM
|
|||
|
|||
Richard:
Thanks for the reply. In response to your first question, The tuning mentioned above has already been done. This is how the car sits now, I have no plans for more, it is a daily driver and a street car only, no tracking ever will occur in this cars life, at least as long as I own it. (Only 6k miles only so far. A Total Garage Queen)  :(Boost - 1.3 Bar sustained @ 6000 rpm, Flashed DME/ECU, Upgraded Exhaust, Bypass Valves, Headers Etc. ) Based on your previous response I need some Clarification. Richard: I think looking at your setup, you need a at least a 1mm jet, expecting you will have around 500-550HP. This based on M50:W50 mix. Ian: Is this for a Single Jet or 2. After some thought I am inclined to go with 2 Jets mounted virtically from the bottom as opposed to a single one as I can get them away from the Plenum which is my preference, does this mean I can get away with say .7's or .8's? Richard: What is the Mehtanol % on your screen washer fluid - recalculate based on the above answer. Ian: This is a tricky one as they do not post it exactly on the products, but I would say 30% - 40% based on some charts I have looked at. Basing it on 10 - 15% RtF would be concervative, I will never go over 50:50. I still am a little unclear on how to calcultate the jet size based on HP and RtF % :?: How do I calculate the flow needed in CC/MIN from the number I have available? 160psi - 20psi boost = 140, a 1mm jet would be roughly 550 cc/min per the chart in the manual. Richard: The HFS-6 can only be triggered by IDC but you can offset the flow with the pressure signal. Ian: Last Time I used the 2s system on the Lotus but It was overkill. I Like the FiA2 concept, The HFS-6 has that Gauge that is a little obvious when in the CAB. I am not a Pod type of guy and think they look a little undignified in this type of car. That is my only issue with the HFS-6. Also Why is the HFS Series not on your web site for scrutiny? :wink: I also like the concept of Boost triggered flow. What also I do not understand is the flow phased in on the HFS-6 like it was on the 2s, and is it also phased in on the 2d. as I do not really understand the adjustments available on the HFS-6 yet, I am still in design mode look at all the options you have In addition on the Porsche everything is in reverse. The Trunk is in the front and Engine at the back. Well as you may know the engine bay is very small and HOT. Can the FCM stay in the front with the pump and supply fluid the length of the car, or should it be closer to the jets? As mentioned I think the ideal would be a 2d with a rotary pump. But one always wants what one can'y get right? Also the 2d system seems somewhat dated in comparison to the HFS Series, is tha true? Bottom line, which pump is better regardless of noise? SWR 
|
|
|
Threaded Mode