#13
|
|||
|
|||
Re: Mini R56 2009 Factory JCW HFS-3 Install (Cooper s owners too)
Quote:
ok. as 0.8mm was the smallest size. i took the next steps with that still installed. i lowered the flow as follows. i inserted the 0.5mm restrictor into the FAV. road tested. no flow. i turned up the SC on the guage. still no flow. i done repeated the above steps again with the 0.7mm restrictor. again. no flow. then i tried the 0.9mm restrictor. yet again. no flow recorded. richard was spot on. together with the newer FAV and the new map on the hfs3 ecu. the flow was already reduced to match the mini. so as suggested by the most people. i drained the tank and ran 100% meth. results. car seems to like it much better than the 50/50 mix. still abit of after urn in the exhaust. but i dont feel any power loss. maybe a bit of power gain. initial testing looks to have gone some way to sort out this problem. will test again tommorow. but i think i may need a smaller nozzle. shall i send you my original FAV and the unused 0.9mm and 1.0mm nozzles back richard. so i can get a few smaller nozzles? |
Tags |
cooper s, hfs3, install, jcw, mini |
|
|