Failsafe wiring for Turbosmart Eboost

[crum86]

Just wondering if it was possible to wire the failsafe from the HFS-3 into a Turbosmart Eboost 1? If so which wires will I need to connect? I'm going to be using the orange wire from the Aquamist for map switching in the ecu

Heres the wiring for the Eboost

-RED + 12 Volts switched through ignition ? connect via 5 Amp fuse supplied
-BLACK Chassis, earth or ground
-GREY Solenoid wire 1 ? connect using wire supplied ? polarity not important
-BROWN Solenoid wire 2 - connect using wire supplied ? polarity not important
-YELLOW Dimmer circuit + 12 Volts
-WHITE Auxiliary output ? switched to ground ? see diagram below
-GREEN External set point 2 refer to section 5d
-ORANGE External set point 3 refer to section 5d