#1
|
|||
|
|||
Peugeot 207 GTI - HFS4 Finished Tomorrow
hi Richard
my system Is being finished off tomorrow morning and just wanna clarify a few points. I will be running around 300bhp on a 1.6litre engine with max 23psi boost. am I correct in saying: 1) the pre amp should be soldered at 2.5 2) MPS at 3 with the high boost running. 3) cut the existing connections to the two above. 4) for the flow sensor, we should solder 0+1 as its a single jet set up. 5) for setting failsafe point 1 says adjust SC to display 5-6 bars at full flow, how do u do that? seen the kit on the car last week and looks brilliant, cant wait to drive it again!! cheers andy |
|
|