2d system on 94 RX-7: pump running continuously?

[scl]

Hello all,

I'm new to WI. I searched, but couldn't find anything on this topic. I purchased a single turbo '94 RX-7 w/ a new 2d system already installed in the rear hatch.

With power switched on, the pump comes on and will not stop until I turn the power off. Fuses are ok. I have primed the pump and verified that at 10 psi there is a nice atomized spray from the injector. I let the pump run for a couple of minutes to remove any air in the system. I spoke w/ the installer of the system and this was not a problem for the 1500 miles he put on the car after installation. The WI was not used for a period of months prior to my purchase of the car. The LEDs on the FIA2 appear to be ok. I don't see any major leaks in the system. A few drops of water are present on the HSV at the junction of the metal body of the valve and the wires.

The system works well, but right now I must turn the system on and off manually whenever I decide to drive the car with "spirit" to avoid damage to the pump. It gets very warm to the touch after its on for longer than a few minutes. HELP!

Stew