waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and new products > Aquamist HFS-3 forum

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #17  
Old 23-05-2010, 07:51 PM
Canonshooter Canonshooter is offline
Member
 
Join Date: Apr 2010
Posts: 30
Default Re: Going with the HFS-3

This weekend I finished up the under-hood part of the HFS-3 install. This included installing the jet in the TMIC, installing the Fast Acting Valve (FAV), the water lines and the electrical work. All of the wires are now run into the passenger compartment for final hook up next weekend.

These two photos show the jet and hardware installed in the TMIC, on the under side of the outlet to the TB. Since the Perrin has cast aluminum end tanks, the drilling and tapping was very easy with plenty of material to tap. I sleeved the 4mm line with 3/6" fuel hose to protect it - on the second photo you can see it pull down over the barb fitting and secured with a zip tie;






The photo below show the FAV installed on the EBCS bracket;



Looking forward to "going live" next weekend!
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 05:19 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.