Injecting prior to turbo comp' impellers

[T.F.S.]

Well moar methanol arrived today so I filled up a 15/75 water meth mix and went for a datalog run...I managed to change the software so the inlet temps are much easier to see too!

After the last run on a 50/50 mix I was expecting temps to be quite low but this was not the case!!!, the temps smashed into the 80c region pretty dam quick



I am not sure why that is...its pretty much the worst temps I have seen yet and I had to check the tank volume to assure myself that the WI system had activated at all on this run

AFR was hitting 10.0/1 which is the lowest my AEM will read (so who knows what the real AFR was)

If this is going to work we are going to need a LOT more liquid injected at this mixture level


Another two runs on different mixtures show the same thing...massive spike on first application

Run 2 50/50 methanol/H20



Run 3 50/50 ethanol/H20



It was obvious something wasnt right here...thats not what you expect from a WI system, a leak was suspected but upon checking could not be found