Aquamist Jet Thread Pitch and Side (Inlet Side)

[stevieturbo]

The inlet side of the jets is a push on hose tail ?

The threaded section that screws into your intake or pipework is M8x0.75mm

[cragg56]

Originally Posted by stevieturbo

The inlet side of the jets is a push on hose tail ?

The threaded section that screws into your intake or pipework is M8x0.75mm

Correct, but the push on portion comes off so that you could use push to connect or other fittings. I am wondering what thread/size that is so that I can get fittings for my mock fuel rail type design that I am planning.

Am I way off here? I actually haven't received my HFS-3 yet, but based on the pictures on the website I assumed that the push to connect fittings were threaded into the jets after you remove the push on hose fitting.