Mazdaspeed 3

[Richard L]

Originally Posted by jdraps13

Okay thank you, so i soldered the stuff as the diagram says except soldered the 3 instead of 2 for my 3 bar map sensor, and set up the jumpers as diagram said but was missing one so pulled the one off PRK and used it instead is that okay?

Do not follow the jump on the previous diagram, they are not accurate. Go by the gold dots (default). Have you solder linked the x2.5 and cut x1?

[jdraps13]

Originally Posted by Richard L

Do not follow the jump on the previous diagram, they are not accurate. Go by the gold dots (default). Have you solder linked the x2.5 and cut x1?

Yeah I did cut 1 and soldered 2.5, as for default jumpers make sure one is on each gold dot?

[Richard L]

yes, those are the default positions to get you started.