![]() |
#1
|
|||
|
|||
![]()
Just added water and all this popped out
![]() after understanding what everything is and does i came across this problem, the tank outlet was already in place and the pump inlet didnt agree with it. ![]() ![]() so i bought 6mm push in fittings to do this. ![]() Last edited by taiman; 06-05-2010 at 12:43 AM. |
#2
|
|||
|
|||
![]()
drilling of injection points, just before the throttle body
loctite ing in place ![]() ![]() lower coldside piping picture ![]() Last edited by taiman; 09-05-2010 at 06:19 AM. |
#3
|
|||
|
|||
![]()
from the boot to the outside
![]() from the back to the front ![]() FAV mounting, underneath the engine bay chassis rail ![]() covering everything with split tube cable protectors ![]() ![]() to be continued... |
#4
|
|||
|
|||
![]()
used velcro to make it stay
![]() now just to mount the tank and tune |
#5
|
|||
|
|||
![]()
This install is well thought out. I didn't want to post earlier until you have finished. Congrets.
One the tank install, is there room for the level sensor? Please test run the system before tuning.
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
![]() Quote:
if you have a closer look at the tank pictures, the level sensor is in place at the back end of the pump. came pre-drilled and installed by Howerton Eng. just waiting on anti-slosh foam now for further piece of mind. |
![]() |
|
|