![]() |
#1
|
|||
|
|||
![]()
been slowly doing this install over the last week. And to see it work properly the first time go... I am very happy. Thanks to Richard for his hard work with diagrams and instructions, which resulted in everything working like they should.
Anyway I will put up some install pictures for now, text and my comments later ![]() Pump in the wheel well (hope it does not effect it seeing its upside down) ![]() the 6QRT tank, mounted on the right side. I am using a bracket to hold it in place. the washer bottle is a pain to get to with the carpet installed. ![]() I routed the supply line to the FAV underneath the car, there are a few places that were tricky and I might re do them when i get the car onto a hoist. but basically running next to the fuel and brakes lines ![]() the picture of the FAV, it can also be seen from the front of the car. anyway there is a big support beam under the airbox, on one side the boost solenoids are.. this is on the underside of the beam. I taped some holes and bolted the FAV there ![]() this is the upper IC pipe jet, surprising the IC pipe is quite thick, and will hold the npt fitting. i used Loctite Red to ensure that its sealed properly. ![]() this is the jet right after the IC. ![]() |
#2
|
|||
|
|||
![]()
good stuff ziad! lets see some figures now!
|
#3
|
|||
|
|||
![]()
nice install ziad
![]() really looking forward to seeing your results. ![]() |
![]() |
|
|