#1
|
|||
|
|||
p0245 and no display on gauge
hi richard. hoping you can help guide me in solving these issues. read manual, went through your search forum here as well.
installed wiring as per diagram. doing quick start and just “water level” comes on for a few seconds nothing else on gauge. also getting p0245 code (white wire tapped to ecu end, brown to other end). checked grounding wires. both red lines posie to brown/red wire. this is for 2017 wrx mike Last edited by thichmt; 09-05-2018 at 02:20 PM. |
#2
|
|||
|
|||
Re: p0245 and no display on gauge
hi richard,
i had put up this post and send you an email 3 weeks ago regarding my issues and not one reply! so i had to pay installer and he had same issue. he tried calling you and going to your site, but the phone call does not go through and website button pulls error message. where is the support for your product? |
#3
|
|||
|
|||
Re: p0245 and no display on gauge
pm me your phone number, I will call you.
I need the serial number of your controller.
__________________
Richard L aquamist technical support |
#4
|
|||
|
|||
Re: p0245 and no display on gauge
message sent
|
#5
|
|||
|
|||
Re: p0245 and no display on gauge
did you receive my messages? I tried sending just now via pm but it said I can't send you pm.
|
#6
|
|||
|
|||
Re: p0245 and no display on gauge
what is the serial number of your controller?
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
Re: p0245 and no display on gauge
sn:121966. just so i know, did u receive any of the emails i sent for past two days i.e. my number, my installers phone number??
|
#8
|
|||
|
|||
Re: p0245 and no display on gauge
The system was made in 2016, has it been in the same car since the first install?
Question: Is the system now in a 2016 wrx, does it have a DIT FA20 engine?
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
Re: p0245 and no display on gauge
no its in different car (2nd owner). 17 wrx so for DIT FA20 engine.
|
#10
|
|||
|
|||
Re: p0245 and no display on gauge
Can you post a picture of the top and bottom of the circuit board (well hi-res focused) here. I like to see the configuration.
__________________
Richard L aquamist technical support |
|
|