#91
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Quote:
|
#92
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Mr reply in green...
Quote:
__________________
Richard L aquamist technical support |
#93
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
excelent support from aquamist directly on this site as well as the wiring diagrams for the few wires that need to be connected
thanks z |
#94
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
This is a question in regards to extending the two cables that connect to the PVM. I can cut/splice to add length or put an extention coupling at the end and run additional cable. However, is the flow sensor set to length and looking for a specific resistance/ohm number ? If I extend it will the readings be off ?
Thanks |
#95
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
No problem extending the wires.
Richard
__________________
Richard L aquamist technical support |
#96
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Thanks....just a quick trick to pass on about running the wires. If you put heat shrink around the ends it keeps the tab from breaking as you pass it through confined spaces. Once its done just cut it off with a razor.
|
#97
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Please explain again, I didn't quite get it
__________________
Richard L aquamist technical support |
#98
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hello everyone,
I have a question. Where the failsafe is connected and how it control my timing/boost whenever I'm out of water/methanol mix, or any other fault condition in the system? My car is a modified 07 STI, and I'm looking into H2O/Meth injection for the first time. Trying to learn as much as possible before making a decision. Thanks and best regards, Guillermo |
#99
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hello again,
What's the size of the gauge? 52 or 60 mm Thanks, GS |
#100
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
The gauge is 52mm
|
|
|