#11
|
|||
|
|||
Re: Mazdaspeed 3
"6" Connection is for alter map sensor ranges.
Not sure what you meant by negative.
__________________
Richard L aquamist technical support |
#12
|
|||
|
|||
Re: Mazdaspeed 3
I think I know what you are after....
Yes, you can follow the diagram exactly.
__________________
Richard L aquamist technical support |
#13
|
|||
|
|||
Re: Mazdaspeed 3
on page 21, 1-6 is for customizing the board, #6 is pwm and it is connected to the negative,
for my 3 port ebcs is that the one i cut |
#14
|
|||
|
|||
Re: Mazdaspeed 3
Now I am really confused.
Can you tell me exact what you want the system to do for you. You referred to a old post on BCV, not MPS sensor range. Start again.
__________________
Richard L aquamist technical support |
#15
|
|||
|
|||
Re: Mazdaspeed 3
Quote:
|
#16
|
|||
|
|||
Re: Mazdaspeed 3
OK, ignore the page 21 posts.
You don't need to do anything different to the system wiring. Just wiring it up as it is the factory BCV.
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
Re: Mazdaspeed 3
Okay thank you, so i soldered the stuff as the diagram says except soldered the 3 instead of 2 for my 3 bar map sensor, and set up the jumpers as diagram said but was missing one so pulled the one off PRK and used it instead is that okay?
|
#18
|
|||
|
|||
Re: Mazdaspeed 3
Do not follow the jump on the previous diagram, they are not accurate. Go by the gold dots (default). Have you solder linked the x2.5 and cut x1?
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
Re: Mazdaspeed 3
Yeah I did cut 1 and soldered 2.5, as for default jumpers make sure one is on each gold dot?
|
#20
|
|||
|
|||
Re: Mazdaspeed 3
yes, those are the default positions to get you started.
__________________
Richard L aquamist technical support |
|
|