NEW product... checkvalve jets

If you have an issue due to gravity or PD then they would help, but otherwise probably not needed.

[Wolf_Tm250]

Originally Posted by Howerton Engineering

If you have an issue due to gravity or PD then they would help, but otherwise probably not needed.

Ok, thank you!

[vlopatin]

Hello, have to of check valve jets installed before throttle into intercooler pipe. Suddenly got "error" lights in my HFS4 controller and find out that one of two nozzle stopped spraying... So my questions - is there any options to make it working back (what should I check)
Thanks in advance

[Richard L]

Originally Posted by vlopatin

Hello, have to of check valve jets installed before throttle into intercooler pipe. Suddenly got "error" lights in my HFS4 controller and find out that one of two nozzle stopped spraying... So my questions - is there any options to make it working back (what should I check)
Thanks in advance

Did you recalibrate the WL and WH after putting in extra, that is the impression I got from your post.

[vlopatin]

Originally Posted by Richard L

Did you recalibrate the WL and WH after putting in extra, that is the impression I got from your post.

Yes, I did. I had 2x0,5 standard type and several month ago changed them to 2x0,7 checkvalve - so it was ok till yesterday. It doesn't work even if I remove it from the pipe and run test (second one is ok)

[Richard L]

If you have one nozzles suddenly stop working, Open it up and check for debris. This is the only cause. Make sure you do it on a clean table top. Make sure every o-rings are seated properly during reassembling.