waterinjection.info  

Go Back   waterinjection.info > Injection Theory (what it is and what it does) > Avoiding Disaster

Reply
 
Thread Tools Display Modes
  #11  
Old 05-02-2011, 01:14 PM
GCCR GCCR is offline
Junior Member
 
Join Date: Aug 2009
Posts: 10
Question Re: Implementing boost/ignition cut

Does anyone else out there actually run these systems on circuit race cars ? (See also above postings).
Reply With Quote
  #12  
Old 19-07-2013, 10:42 PM
GCCR GCCR is offline
Junior Member
 
Join Date: Aug 2009
Posts: 10
Default Re: Implementing boost/ignition cut

Hi Richard......a couple of things......

a) Flow meter. This was working as well as it can on my system but really the signal output / measured flow is too sporadic to be of any practical use. I was using the output to trigger additional advance and less fuel (when flow was detected). Trouble was whenever the WI map dropped off the WI injected areas at low boost, it took ages to show flow again then back onto boost and water was injected again.

b) I've had a bad off and fire so need to replace the push in 4mm outlets on the pressure monitoring block but I can't see them on the site. Are they still available ?
Reply With Quote
  #13  
Old 20-07-2013, 09:54 AM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,936
Default Re: Implementing boost/ignition cut

a) What is the serial number of the flow sensor? Some can be clean and serviced.
b) Push in connector has been replaced by compression type a few years ago. Push-in fittings have a tendency to leak after a few years of service.
__________________
Richard L
aquamist technical support
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 05:09 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.