Canonshooter
24-05-2010, 12:23 PM
I just want to make sure I'm reading the diagram below correctly;
1. I am only using IDC so the MAP sensor connection to pin 6 is not required (the MAP option is not progressive, on/off only - correct?).
2. IGN-SW #2 is pin 19
3. No external engine management for map switching, so the MAP SW connection is not needed.
4. FUEL INJ (-) is pin 11
5. OE Boost solenoid is pin 27
http://www.aquamist.co.uk/HFS3/Subaru/wrx/H3-07wrx.gif
1. I am only using IDC so the MAP sensor connection to pin 6 is not required (the MAP option is not progressive, on/off only - correct?).
2. IGN-SW #2 is pin 19
3. No external engine management for map switching, so the MAP SW connection is not needed.
4. FUEL INJ (-) is pin 11
5. OE Boost solenoid is pin 27
http://www.aquamist.co.uk/HFS3/Subaru/wrx/H3-07wrx.gif