View Full Version : Aquamist HFS-3 forum
- Aquamist HFS-3 system for 2010 ..... "Q and A"
- HFS-3 GB
- GB Howerton Engineering Tank Offer
- Has everyone received the v2-grey cable?
- Please post installation pictures of the HFS-3 here
- HFS3 problem
- Kit installed-here's what I see
- Do I have a faulty relay? ::fixed::
- HFS-3 was working... now a hiccup ::FIXED::
- Leaking jets?
- Decreasing Flow as I reach redline.
- Tune results
- Fav
- Going with the HFS-3
- Gauge turning off for a little while?
- Gauge affects dimming of interior lights? Is this normal?
- MAP Failsafe Wiring?
- Mounting the FAV
- FAV Location
- Working out restrictor size for an Audi RS4
- setting up fail safe eta
- Post install, pre-tune driving...
- Confirming ECU Connections
- ECU Load/Injector Calculation
- hfs-3 gauge
- gauge seem to read differant depending on road speed or high or low gears
- S2000 Greddy turbo kit results
- HFS-3 shuts down after blue trunk wire is attached
- HFS3 initial setup query post install
- Strange setup problems
- HFS-3 Question
- HFS3 Supplied Hose Dimensions
- Using 806-155 instead of MAP sensor?
- HFS-3 results... +5 degrees ignition timing
- HFS3 power supply issue
- HFS-3 Eaton Charged 1600
- jets for 3sgte with 650 cc injectors
- Just installed HFS-3, couple questions
- inconsistent flow meter readings
- HFS 3 + compustar remote starter = CEL and more...
- question about failsafe and greddy profec b2
- Gauge Power problems
- Problem no power to gauge
- Gauge not reading full bar anymore
- Thread size?
- I have a headache!
- Can I use HFS-2 instead of HFS-3 for my 335i setup ?
- Second issue with power to gauge
- Power Issues/Seems to be related to ESP/ABS -- Audi s4
- Controlling FAV via standalone
- LED flow problem with gauge
- Need help
- No power to gauge
- help with road test jet....
- Gauge problem?
- Installed a HFS-2 system on my 335i with N54. I have some questions.
- Hfs-3 996TT
- Has anybody had their pump die on them?
- Datsun 1600 HFS3-Help needed
- HFS-3 does not show all bars anymore?
- Faulty FAV valve?
- Pump is activated after a while when the motor is not running
- HFS-5 Pump Question?
- Failesafe question
- Boost trigger
- HFS-3 in porsche 997TT
- Adjusting thres and gain having no effect
- Restrictor
- Pump problem
- What size flow restrictor? dual 0.8 nozzles?
- HSF 3-v2 for Porsche 964 turbo 3,6
- Trying to adjust failsafe on gauge, not sure what im doing wrong?
- Restrictor and Bubbles Question
- HFS-3-V1 Upgradeable ?
- have qusetion please
- 997TT issues?
- Hydramist or HSF3 ?
- Jet Placement 996TT?
- how to disassembly the FAV in HFS-3 to clean it up?
- HFS-3 what did I just buy?
- Installation of HFS-3v2 on Peugeot 207 RC (EP6DTS)
- Diagnostic port for level sender, which one?
- HFS-3 power issue troubleshooting
- Problem with HFS-3 ::fixed::
- HFS-3 not spraying ::mystery solved::
- System Won't Turn On ::Fixed::
- injector duty cycle question how it controls the aquamist
- Best place for nozzle placement?
- Evo IX USDM fail safe (Mac valve) diagram?
- 2006 STi Gauge turns off when Blower fan is turned on ::fixed::
- HFS-3 pump runs on after pull
- HFS-3 & DDS3
- DDS-3 version 8 map sensor problems
- Replacement DDS3 V10
- Stainless Tubing
- Hfs-3 gauge randomly shuts on and off
- When I switch off my car, the pump goes on even the switch is off ion the gauge.
- Couple of questions about input /output
- Hks evc boost controller
- Hks evc boost controller
- HELP: Peak and Hold Low impedance Injectors
- WL and WH
- No bars at all
- Building a tank
- HFS3 PWM control
- Failsafe always on
- Shorten cables
- Failsafe (WI and WL) always ON
- 997TT wire colors??
- flow sensor
- INSTALLATION HSF3-PWM ON MINI COOPER S R53
- poor atomization below 20% duty cycle
- Wiring issue
- New Install On VL Turbo
- Failsafe wiring for Turbosmart Eboost
- 2007 Subaru legacy spec b to hfs-3
- problems with FAV solenoid - no work, but getting very hot! ::fixed::
- failsafe
- Wiring diagram for peugoet 207gti 128kw (fsi motor)
- HELP! HFS-3 wont work! ::DEBRIS IN FLOW SENSOR::
- Do I need a restrictor??
- 2000 Audi S4 HFS-3 not spraying ::CORRODED PUMP::
- Leaking coupler
- Install after engine rebuild
- Tubing off Tee no tthe same. Does it matter?
- Help setup trigger.
- Jets leaking!
- Air in the lines
- something is wrong .. :s
- HFS-3 failed the driving test ::FIXED::
- Guage cable too short. Computer network cable good? ::DON'T DO IT::
- CUSTOM AQUAMIST GAUGE?
- E36 M3 3.0L Twin Turbo + Aquamist HFS-3
- Flow no more than 2 bars
- Length of 4mm tubing from FAV
- Aquamist Jet Thread Pitch and Side (Inlet Side)
- Help Needed
- Install HFS-3 on DI engines - any need to connect MAP sensor?
- Water level indicator
- Nozzle selection on 04 WRX 2.0L
- Water injection and water level lights after hitting threshold.
- wiring problem
- Wanting to do a Pre-turbo setup info please
- Fav not opening
- HFS-3 with big fuel injecters
- FAV Nut
- HFS3 not spraying
- failsafe wiring diagram to oem ecu
- Jetting size help
- SC trimmer not working?
- Trimmers
- jetting size and restrictor
- HFS-3 pump flow
- hfs-3 to aem ems in 02 wrx
- 997 turbo .. something is going wrong
- Correct Jet Size 06 wrx 2.5L
- HFS-3 Injector size Calc
- HFS3 5A fuse blows on power up
- HFS3 Ver 2 onto 8L Audi S3 1.8 20VT
- evo X Hfs 3 issue
- HFS-3 and Omni 4Bar MAP Sensor
- HFS 2 Volvo 2003 and 1998
- Help with HFS-3 and MPS Trigger
- HSF-2 for STi running Link G4 standalone
- HSF-3/2 and low impedance injectors + resistor pack
- Low resolution on SC knob on HFS3
- Gain setting issue -HFS-3
- Multiplier
- Failsafe Kicking in
- HFS-2 to HFS-3 fail safe no flow bars
- Pump dying?
- Failsafe activated
- HSF3 EVo 9 and AEM series 2 idle Issue
- HFS-3v2 wiring diagram Mazdaspeed 3
- Linking DR1
- HFS-3 troubleshooting
- Fail Safe on an NA 2011 Corvette Z06
- Map switch with onboard relay
- Flow sensor pulse output
- IDC sensing HSF-3
- Datalogging HFS3v3
- Aquamist HFS-3V2 Not injecting
- FIDC too low for HFS-3 V3
- failsafe problems ::cause found::
- Peugoet 207 Gti help needed
- peugeot 207
- Wiring Aquamist to AEM EMS
- HFS-3 problem :(
- Flow Sensor issues on new install
- HFS-3 Water Level Light on
- dash gauge
- Setting fail-safe clearification
- New Install Failsafe issues
- Pump Activation
- Pump fitting to tank
- Gauge turns off after car is started
- Failsafe... I think
- BMW 335i HFS-3 power problems
- Adding jets for IC prayer?
- HFS3 install on Mazda CX-7 (2.3T)
- What are scroll Jets?
- New Install STI failsafe issue
- IDC trigger point datalog
- causes for irratic or low flow readings
- Power source
- HFS-3, testing flow rate of 0.6mm jet.
- How to:compensate knock occurrence during spool up
- Duty Cycle vs Optimal Atomization vs Jet size
- HSF-3 pump not working
- HFS-3 thres problem ::repaired::
- MAP minimum treshold voltage
- new instalation question pump/fav
- HFS-3 Activation point
- GTR35 Wiring Diagram for HFS-3
- Ultimate first post
- Audi BUH engine install questions
- W.Injection Partially Lit Up
- HSF-3 stopped working? How do you link the FAV & SYS to test system?
- HFS-3 dash display
- Trouble Shooting Help
- Injecting with IDC vs MAP signal
- Help me about HFS3-V3
- Documentation on how IDC injection works?
- HFS-3 problem, Getting low water light
- Gauge Calibration
- HSF-3, pump not working
- Failsafe with HKS EVC 6
- System will not trigger from IDC
- Partial removal question, nozzles in the intake in particular.
- 15 A Fuse keeps blowing
- HFS-3 'box/control unit' sending voltage out the green wire, HELP.
- HFS-3 Flat Black Gauge cable
- Need help with wiring for 1998 Trans Am
- Gain trigger setup
- Looking for right angle 3/8BSPP to 6MM
- "W.Injection" Staying partially lit
- Jet sizing for Hellcat
- Failsafe, and some other questions.
- HFS3/Summer unit installation queries on a 1995 FD3S Mazda RX7
- MPS trigger issue
- FAV flow issues on 2006 R53 Mini Cooper S
- HFS 3 diagram and FailSafe issue.
- HSF3 installation difficulty
- Hfs 3 help needed
- Help with setting up the HFS3 on Evo9
- HFS-2 Help needed.
- First time start, no power or anything
- HFS2 Question - 1.8T
- FAV not working from controller
- no green LED
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.