View Full Version : Evo IX USDM fail safe (Mac valve) diagram?
dsm1gb
23-11-2011, 03:55 AM
I'm trying to figure out how to wire my mac valve for fail safe with a MBC on my evo IX (USDM)
I cant find a diagram, this is my last step so any help would be greatly appreciated.
Richard L
23-11-2011, 02:32 PM
I think this one should work.
http://www.aquamist.co.uk/HFS3/EVO/USDM/H3v2-MBC-evo9.gif
dsm1gb
10-01-2012, 08:33 PM
So I have my Mac valve connected to a constant 12volt source, the same as my boost gauge, wideband etc, Is this correct to have power to it at all times?
Richard L
11-01-2012, 12:29 AM
It would be much better if you can connect the mac valve to a switched 12V, active only at the "pre-crank" or "run" ignition key position.
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.