Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Thanks for the update. One more question, how many 0.7mm jets are you running?
It appeared you are injecting too much, putting out the spark or burn rate is slow. I |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Quote:
|
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
It is interesting a 0.7mm jet will affect your engine so much. Can you try running 80% methanol. This test will identify if the previous 50/50 was loading the ignition system.
Where is your jet installed? |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Quote:
Ok, I try 80% methanol and what I must to see on dash? |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
How far is the exit of the intercooler to the throttle?
If you are not getting good even distribution to the cylinders, it could cause poor bad burn on one of the cylinders. Is it possible to move the jet further away from the throttle? |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Quote:
I watch the knock retard and it is not. |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
I really don't know. sol we shall approach this one step at a time. Can you send a picture of the nozzle installation.
|
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
2 Attachment(s)
Quote:
Richard please say something...((( |
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
I've just installed one of these kits the question is do you need to wire in the user as the kit was supplied with it, it's a hfs4-v3
|
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
You can follow this drawing:
http://www.aquamist.co.uk/vbulletin/...ead.php?t=2188 |
All times are GMT +1. The time now is 06:48 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.