Engine control unit to Aquamistcontroller
i control the Aquamist controller via a map sensor. Unfortunately, my engine
control unit does not get along when water is injected and therefore the engine is not running properly. I would now like to use my engine control unit to control the Aquamist controller. Unfortunately, I find in the manual no way. What can I do? Gunther |
Re: Engine control unit to Aquamistcontroller
what can i do with the AUX-Input options?
|
Re: Engine control unit to Aquamistcontroller
I need the following information:
1. Serial number of the HFS4 controller? 2. What car model do you have? 3. Why spray with boost instead of IDC? |
Re: Engine control unit to Aquamistcontroller
Hello,
1: SN:121970 2: Lotus Elise Rover VVC Turbodrive 3: how the boost works was clear to me. I don't understand IDC. How can I set the power-on limit? Gunther |
Re: Engine control unit to Aquamistcontroller
now the system runs over IDC. But it's still the same problem there
|
Re: Engine control unit to Aquamistcontroller
Remind me what is the problem with IDC.
|
Re: Engine control unit to Aquamistcontroller
when I drive at full throttle and then take some throttle out the engine starts to ring through the throttle and the lower water flow rate. That's why I had to take the ignition back.
|
Re: Engine control unit to Aquamistcontroller
are you running M50/W50?
|
Re: Engine control unit to Aquamistcontroller
running with Methanol 60/Water 40
|
Re: Engine control unit to Aquamistcontroller
thanks for the answer.
Two more questions: 1. What is the HP of the car 2. What is the fuel injector size. |
All times are GMT +1. The time now is 10:53 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.