![]() |
#51
|
|||
|
|||
![]()
Ok I can do that. What if I add a bigger jet? Also how do I dial in the trimmers, just trial and error until things come on and max out when I want them to? Also if I solder the link can I then run the controller on full boost? TIA
|
#52
|
|||
|
|||
![]()
1. link 1&2 or two jets.
2. Cannot answer your question until I know the map sensor range and the boost pressure. You can estimate the map sensor range by probing the voltage on test point 17 at pre-crank. Can you do this?
__________________
Richard L aquamist technical support |
#53
|
|||
|
|||
![]() Quote:
Have you ever read the user manual?
__________________
Richard L aquamist technical support |
#54
|
|||
|
|||
![]() Quote:
![]() |
#55
|
|||
|
|||
![]()
I am sure you will go much further doing this on your own. You are not strictly our customer, you bought this second hand?
__________________
Richard L aquamist technical support |
#56
|
|||
|
|||
![]()
Funny when people actually live up to there names! "Awesome" manufacturer sponsor! Hopefully the people that find this thread while researching your product will have a better inclination on what they're getting themselves into then I did. I'll make sure the forums, car clubs, and Facebook groups I'm a part of know about you guys! Pip, pip, cheerio!
Last edited by Jroyalty7; 18-09-2017 at 10:22 PM. |
![]() |
|
|