Re: Wiring issue
Test point 8, the voltage should drop considerable more.
Where did you spice in the the green wire of the grey harness? |
Re: Wiring issue
K I think I have my problem figured out I was using the Wrx wiring diagram not the sti one so I will try hookoing it up that way tomorrow and see if that works better.
|
Re: Wiring issue
please update.
|
Re: Wiring issue
K I redid the wiring with the right wiring diagram the system seems to be working perfectly now. Thanks for all your help
|
Re: Wiring issue
Great news, thanks for the update.
It did puzzled me for a while. |
Re: Wiring issue
Hi there, I have similar problem, so I ran diagnostic on points you suggested, and while TP5 and 8 are getting ca12.3V with engine off/14.4 engine on, point 23 won't give more than 0.25V.. At this point I am sure some contact is wrong, just have no idea which, and cannot find pin description anywhere. Just to complete info, I am running first test described in the manual, w/out FAV, etc connected, and I am getting no reaction from system at all.
|
Re: Wiring issue
can you measure the voltage on the 5A fuse. Both side.
|
Re: Wiring issue
0.26V, both sides.
|
Re: Wiring issue
Check the red wire of the power connector (4-way molex type), there should be 12V there.
|
Re: Wiring issue
11.16V with engine off.
|
All times are GMT +1. The time now is 12:54 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.