HFS4v3 on 2013 Mazdaspeed3

[porterhouse07]

Originally Posted by Richard L

It is the same.

Post a picture of the controller topside.

I'm not sure why my picture didn't attach to my last post. But I Have the image attached again below. It does seem as though it is configured for a 3.5bar MAP sensor so I'll I should have to do is rearrange the jumpers for the x2.5scaler correct?

I also bought your tank as was trying to figure out how this thing is supposed to mount in my car if I mount the pump to the bottom of the bracket. I don't see any other mounting points except for the ones to mount the pump.

Thanks for your help.