New to forum / Custom WI system for AUDI

[Richard L]

I will send you an accumulator if you like - in return or the test you are performing for me.

If you can stick to the same nozzle as your used before, it will be fine.
Shurflo as three cam profiles, cam angle dictates the flow and pressure. 2 deg, 2.5 and 3 deg.

If you detatch the motor from the pump head (three bolts), the cam angle is cast on the pump head part. This is very impotant as using the wrong motor may cause premature thermal cutout sensed by the internal thermal switch. All these information is based on the original shurflo specification, not sure if this applies to the copy.

Switch mode PSU is great, if you could test in 1 volt increments, it will be great, If you also record the current drain, you only need to do the test once. All I need is the pressure, I can calculate the flow from pressure.

Thanks.

Richard


Richard