- Help please... ...system1S
- Aquamist 1s problem - MX5 SC
- Nozzles and methanol..
- MBT timing and ratio of water
- Eaton blowers and their teflon coating
- Aquamist mounting jet
- (91octane + water) Vs. (100octane + water)
- dyno test suggestions
- Diff. in tuning a 15wt%MeOH-water Vs. 50Wt%MeOH-water mix
- How necessary is a solenoid on WI?
- Soot Free brand alchohol/fuel
- Nozzle placement question
- I just sent an e-mail to Mag-charger
- Adding a flow guage to the inj system
- How post-cylinder EGT relates to pre-turbo EGT
- Where to begin?
- question for Richard.....
- WI flow control
- MF" Controller
- How to adjust onset of WI?
- Thomas Knight ESC-350 supercharger and water injection
- Novice: Advice on current setup
- Max.HP on 95 Octane with WI ?
- Multi Port WI, Nozzle Placement
- Internal i/c cooling with w/i or go for port injection?
- W/I cooling potiental on s/c discharge temps?
- Inlet temps?
- My new Water/meth results, with just the change of nozzle.
- Fuel injector for water injection?
- water injection questions
- Thoughts on nozzles
- jet placement: why not cool combustion, not the manifold????
- 300ZX SETUP
- Pre turbo injection during off boost theory.
- Another approach to tuning with W.I. ?
- What jet size?
- Nozzle size for dsm
- Pre-Turbo Water Injection Works!
- Running WI with Emanage Ultimate
- shurflo pumps - pulsing fix
- 100 octane<93 octane
- Dumb Question
- Looking to go W/I...need some advice
- dyno this mon,tues,wed.....
- EVO 8 WI kit recommendations wanted
- What size jet for a 1.8l Mazda Miata with M45 supercharger
- New to forum / Custom WI system for AUDI
- can i do damage?
- det suppression/ tuning tips
- 0-5 volt egt gauge
- what is the best period time for ERL HSV?
- PUMP QUESTION
- Spray video?
- trying to form my own opinion but
- System 2D and jet size/pump pressure flow question
- WI not Spraying?
- help with 1s not pumping
- Basic setup for supercharged rsx
- Is a 1qt can enough?
- direct injection of ethanol in a turbocharged engine
- 8-71 on a 400 ci Small block Chevy
- possible incorrect part shipped
- What psi do i set the pressure switch on a 2d?
- Pump malfunctioning and Nozzle Question
- how do i hook up water-meth injection on a 1982 sigma turbo
- Accumulator placement
- What do you suggest
- Where to put a water hammer arrestor?
- pressure switch question
- wi questions for a strange car
- pre turbo injection installed
- Hooking up an Aquamist pump to a Coolingmist nozzle
- bad cylinder distribution?
- Direct Port Injection
- need to know injector info....
- Compressor surge in pre-compressor injection
- Pre and Post M90 setup need help
- water injectors placement 1.6 liter engine turbo
- Injector size for a modded GT-four
- 2C injection table examples needed
- Dual jet correct position
- Advice on setting up a Aquamist 2c
- Egt limited engine
- Jet placement
- Need some help guys!
- Half installed but now I have questions
- What setup for a 2.8 v6 vw engine with Screw charger.
- Direct Port Injection on Honda S2000 with ITB's
- Jet Positioning - Before Intercooler or After?
- Custom made WI with a fail save system (see drawing inside)
- Aquamist needs your help...
- Fitting HSV to other manf kits
- Help with a parts list?.
- HFS-5: how to map it
- Loosing water from lines, port injection?.
- Primer pump higher than resovior?.
- Audi S4 B5 and W/I
- New idea for 100% menthanol injection
- installing nozzle in 3mm thick aluminum pipe???
- 2D install on supercharged MX5
- AMG 55K motor injection point?
- Manifold pressure switch
- Baffleing water injection tank?.
- Pre and post supercharger jet installation?
- HFS5, making it run. Is it normal that:
- Special Setup on Subaru Impreza STI MY2002
- 1s or 2d
- Water injection (Spearco) set-up questions
- need help instaling aquamist 2c system on vr6 turbo
- Pre-compressor mist and "apparent" boost reduction
- Melted piston using methanol
- nozzle placement: perpendicular or parallel to air flow?
- "Hotwiring" Shurflo pressure switch.
- Heatsoaked intercoolers, pre intercooler injection?.
- Inline turbo six cylinder with six Aquamist nozzles Methanol
- Does WI cause problems with Intake Air Temp sensors?
- Pre turbo injection on RX7
- Nozzle Placement -Before or after recirculation valve?
- DDS3/2D Install - Blowing 15 Amp Fuse
- Help needed....
- DDS3 V8 Install questions
- dds3/1s wiring
- 480 hp project nozzle size
- Please look over my plan .. W/I Audit
- HFS-5 Evo VIII Initial Tuning Notes, feedback requested
- Help my pump has stopped working
- who's using a RRFPR?
- Need to decide between those two setups
- High Boost + W.I
- wil afm be ok
- MAF vs Boost for Roots blower
- Do we really need methanol?
- 1S system work on a blown 5.0 Mustang
- When to trigger on injection?
- How is pump pressure/volume controlled and mapped with a WI
- Nozzle sizing for 2d AND FLOW LIMITS
- grand prix GTP: AFR need some help
- RECORD power for pump fuel & WI street 13B (VBOX data)
- WI on my Supra
- Knock tendency depending on Water Injection and Ignition
- Aquamist Nozzle flow rates
- Desperate for 2d help
- Pre-Turbo Question
- Pump and Resovior Installation Idea on my 240sx
- Need help with 2D wiring!
- Perrin PWI-1. Will not put out more than 250cc. IDEAS??
- 87 octane!! help
- AFR leaner than 12,5:1 question
- Info on George Wiseman books
- 1.4 BAR on ceramics
- Need a controller...
- VW Denatured Alcohol Tuning
- will race pump supply two 10gph misting nozzles?
- 2d System and 1993+ RX-7s
- Aquamist worked, but not after re-install
- system 1s on Vr6 Supercharged
- help! pump and tank placement
- LOW octane
- Uno Turbo 1400cc
- Help choosing injection method for 4G63 motor
- piggyback ECU, open/closed loop and WI?
- Some questions about proper Water / Methanol mix
- W/I injector nozzel size??
- PN# for flow restrictors/connecters.
- Please Help, HFS-5 system WL &WH inop.
- Injector pulse Pin 17
- MF2 and 2 or 4 Injectors?
- The tubing split that runs into the engine bay
- Is Lysholm LYS1600ax supercharger alcohol injection friendly
- HFS5 /2S questions
- 806-244 valve gone bad
- Options for 700HP 2.0L using Standalone ECM
- Water/meth injection efficiency without intercooling.
- Problem with the Pump of the D2 System
- Audi TT nozzle size/flow rate question
- Volvo T5 Aquamist tips needed for new user
- Problem with test of 1s system - advice required please
- Mix is draining, will a solenoid help?
- 0.9mm nozzle is it to big
- can i use an autometer pressure gauge for wi
- RLTC and Meth?
- vw 16v turbo high compression and non intercooled
- Help with float sensor/water level on S60R
- Installation and first system testing
- Need some help on custom setup
- 2005 Porsche Twin Turbo "S" & WI (Proposed)
- Using WI on RX7 Turbo 1991???
- Supercharger setup
- Second control source for pump controller
- system 2d problem
- copper tubing
- pump stuck in priming mode?
- System 2d install instructions
- Just Purchased HFS-6 for my Porsche Turbo S - Some Questions
- 2D System stuck in priming mode??
- Sensor Calibration adjusted and engine is sloppy.
- Check Valve
- Water anti-freeze
- Nozzle size - Richard?
- Running two jets
- W/M Inj on Vag 2.0 TFSI
- Reduce Flow in Winter?
- Which kit
- MP62 + 14GPH Nozzle?
- which nozzel i need ?
- How much power should i be making once meth injected??
- O2 Sensor Heater Codes with Meth Injection
- gm 3.3 bar sensor location
- Smart roadster application
- What size jets
- pictures of pre-turbo injection setups, please
- Meth and aluminum
- Help Choosing Setup
- Pre turbo + pre TB setup. No fmic? help needed.
- 91 gtr
- Guidence with WI setup idea.
- problem with amount of w/m and system setup
- new install, pre turbo water injection
- Flow sensor cleaning
- Yes, another "WTF do I need?" question.
- Higher compession supercharged V8
- Newbie
- Closed loop fuelling and methanol injection
- General usage questions
- Porsche 964 Supercharged Plit Screen VW
- Is a cooler spark plug required after WI fitted
- water injection to overcome high compression ratio
- WI error on dyno but not on road!
- Supercharging BMW E90 N46B20 320i 4cyl
- New HFS-1 system not working
- Subaru EJ 20T
- Air leaks and bubbles
- New to injection
- Bentley Continental GT
- Tuning Aquamist ??
- 08 Raptor HYBRID supercharged ford 4.0ltr 6 needing water injection
- Planning to Aquamist my 4g63t
- V8 supercharged/carbed Mustang GT...
- info needed
- MK4 Golf R32 turbo
- Injection help
- Injector size??
- Direct Port on Mazda RX-7
- Nozzle location
- WI and running rich
- Effect of Water/Meth injection on spark plugs
- Newbie needs guidence
- Tuning on a supercharged 911.
- max water/meth ratio you've been spraying to your engine ?
- looking to purchase hfs-3/few questions