- Real world data from Pre Turbo WI (7 replies)
- 'straight meth' mixtures (0 replies)
- mixture and water absorbtion (1 replies)
- Boost juice changing line color? (0 replies)
- M1 vs M5 (1 replies)
- Deionized vs distilled water (0 replies)
- 50/50 Mixture (4 replies)
- Hydrometer : Methanol Tester (1 replies)
- Mixing my own WM50 - questions.... (1 replies)
- best pre turbo mixture (5 replies)
- VP Racing M3 vs. M5 (2 replies)
- Bio-ethanol (2 replies)
- Testing methanol purity ? (9 replies)
- HFS4 Ethanol question (4 replies)
- Windshield - which one ? (3 replies)
- recovered 97% methanol (7 replies)
- Water Methanol AFR Calculation (3 replies)
- using kerosene to clean intake valves on DI engines? (5 replies)
- Nozzle size help (1 replies)
- Comma window washer concentrade (2 replies)
- methanol supplies (3 replies)
- Methanol Stockists in Derbyshire? (1 replies)
- 100% Methanol injection evaporation/condensing/cling (2 replies)
- Which way to 50/50? (2 replies)
- volume vs. mass (1 replies)
- Pure Distilled Water (13 replies)
- RX7 rotary power, meth or water? (32 replies)
- EFOY methanol (3 replies)
- Porsche 964 Supercharger and no Intercooler (2 replies)
- R0N93 + 15% of 50/50 watermeth = RON? (5 replies)
- Water Vs. Meth (13 replies)
- Water + ethanol/isopropyl (5 replies)
- Experience of isopropyl - good read (long) (16 replies)
- water & ? (1 replies)
- blend 99,5% methanol 0,5% klotz oil (4 replies)
- No-tune mix (5 replies)
- 50/50 mix spayed on intercooler surface. (1 replies)
- Opps! I melted my engine... (2 replies)
- windshield fluid??? (3 replies)
- How's my Math? (0 replies)
- Merits of water in a mainly methanol mixture?. (17 replies)
- injector size on 1400CC turbo renault???? (3 replies)
- Stupid Question: Meth / Water 50/50 injected after IC (3 replies)
- mixture for chargecooling (2 replies)
- Nitrous and Meth in a Wet Nitrous setup?? (1 replies)
- Water/Methanol mix and AFR's (3 replies)
- 100& Alcohol injection ? (2 replies)
- "Best" mixture for port water injection?. (9 replies)
- Maximum methanol concentration for Early Erl pump?. (2 replies)
- Simple test for insuring I actually have methanol? (1 replies)
- 96%+5% Methanol, can I use this for WI? (3 replies)
- Point of methanol or alcohol? (2 replies)
- Methanol substitute to prevent freezing? (4 replies)
- Nitropropane (1 replies)
- Methanol & lubricant (3 replies)
- Help with nitromethane mixtures (0 replies)
- non-aqueous propylene glycol (NPA) a viable mixture? (2 replies)
- Grade of methanol and nitromethane (0 replies)
- Any alternative to methanol? (1 replies)
- Magnets (3 replies)
- fuel additives (0 replies)
- H2O2 (1 replies)
- size of water&temp (6 replies)
- Suggestions on water/alcohol ratio (6 replies)
- Suggestions on engine setup and water/methanol mixtures. (4 replies)
- Toluene injection? (3 replies)
- did something stupid (2 replies)
- Methanol evaporating from the mix? (3 replies)
- Methalated spirits (6 replies)
- Flammability of Methanol/Water Mixtures (3 replies)
- Using A/C condensed water to fill W/I tank? (1 replies)
- Choosing the right nozzle...again (0 replies)
- using heet (1 replies)
- engine temp increase with prolong methanol use?? (1 replies)
- How to measure the right amount for a special mixture? (1 replies)
- Screen Wash (1 replies)
- Survey! What % do you inject and for what purpose? (4 replies)
- Quick question on material compatibility with methanol (1 replies)
- Is Lubrication needed in a WI mix (2 replies)
- acetone (5 replies)
- water + alcohol: % by volume or by weight? (2 replies)
- Need help.........DDS2 not working correctly (1 replies)
- could methanol cause engine damage? (2 replies)
- Injecting high concentrations of alky? (32 replies)
- heet? (6 replies)
- water + denatured alcohol (8 replies)
- water mixture help? (7 replies)
- Nitromethane sources in UK (0 replies)
- Newb to WI (2 replies)
- Uplon Fuel Lube...where in UK? (0 replies)
- Newbie seeks mixture assistance. (2 replies)
- Water injection mixture notations (4 replies)
- using windshield washer fluid or isopropanol (6 replies)
- How Long Can Methanol Be Stored? (2 replies)
- Source of Methanol in Los Angeles? (1 replies)
- Superoxygenated Water/Methanol Injection (74 replies)
- Rainwater - is it clean enough? (20 replies)
- Newbie Here With Question About Water Injection (1 replies)
- running deantured alcohol (1 replies)
- Injecting Xylene mix instead of Methanol? (9 replies)
- Ratio of 50/50 Water-Methanol to be injected (1 replies)
- whats a good ratio???? (3 replies)
- can you use windshield wiper fluid??? (3 replies)
- Ethanol more conducive to knock?? (4 replies)
- Nitromethane from RC Car Fuel? (159 replies)
- NOx (2 replies)
- will be a good nozzle size? (2 replies)
- Calculate your correct injection Percentage ! (19 replies)
- 100% Methanol = Rich Mixture ? (16 replies)
- Methanol in hatchback dangerous? (1 replies)
- Methanol supplier in Denver CO? (1 replies)
- vinegar (4 replies)
- Antifreeze in the injection mixture? (5 replies)
- Gas Line Anti-Freeze (2 replies)
- Shurflo pumps and resisting methanol (1 replies)
- Chart for Latent Heat of Vaporization for various liquids??? (3 replies)
- 90% Isoprol Alcohol knocks more than 70%--Why? (3 replies)
- VM & P Naphtha (2 replies)
- OK just water? (2 replies)
- one response to misfire (1 replies)
- Source for Methanol in Southern California (1 replies)
- Why different mixtures of methanol (5 replies)
- Denature Alcy (1 replies)
- water turn on boost point for base system (4 replies)
- what kind of water ??? (6 replies)
- About WI for 3sgte! (2 replies)
- Pure Water? (7 replies)
- good water/fuel mix for a home built system (5 replies)
- Methanol risky? (10 replies)
- 100% methanol seems preferable (23 replies)
- METHYLATED Sprits can this be used? (5 replies)
- Freezing Point - Best Mixture (12 replies)
- Source of methanol in the UK (26 replies)
- methanol vs Ethanol (4 replies)
- Good source of Methanol (15 replies)
- Different mixes for the water injection and the down sides (19 replies)